Advertisement
www.aeroplusrc.com
service@aeroplusrc.com
Unpacking
Carefully unpack the model making sure that if you use a sharp knife to open bags, not to cut any covering on the
model. Inspect each item to make sure no transit damage has happened. If you are not happy with any part or
are unsure please contact the Dealer that you purchased from.
Covering
Due to the model spending time in different climates zones from the factory on its way to you, some of the
covering may have wrinkles. We highly recommend that you take time to re‐seal all covering edges with an iron
and to use a heat gun to remove any wrinkles and re‐tighten the covering. It is best to do this now while the plane
is not assembled, remember to not let any heat get near any parts like the canopy or cowl as this may cause
damage.
Assembly Tips
We also recommend that you go over all the accessible joints with cyano glue. Wick glue into areas of high stress
around the U/C plate and motor box.
Use Nutlock on all metal to metal joints. Even if you are using electric with low vibration levels it will make sure
that things do not drop off your airplane!!
AeroPlus RC Copyright 2013 © All Rights Reserved
Advertisement
