Remove the elevators and hinges from the rear stab and place it in the opening.
It is important that care is taken when aligning the rear stab. Measure each side to make sure that an equal amount shows on each side.
Fit the CF wing tube and looking from the front and back check that the elevator plate is in horizontal alignment to the rear stab. If it is not then trim
the opening so that it is equal.
Fit the wings and measure from the end of the wing to the elevator stab to make sure that both sides are equal
Glueing – Once you think you are ready to glue, measure again. We recommend 2 methods for gluing. Either remove the covering on the area that is
covered by the fuselage and glue with epoxy or leave the covering on and glue with thin cyno. Wicking in thin first, if a large gap is visible then use
medium or thick. Remember to wick in small amounts at a time keeping the plane level, this will ensure the glue stays where it needs to be.
Depending on if you are fitting 1 or 2 elevator servo's you may need to fit the elevator joining bar.
Work out how much of the joiner bar need to go into the elevator half by laying the bar over the halves and setting the same length as the rear stab.
Open up the covering at the inside of each of the elevator haves and mark the area of wood that needs to be removed.