Advertisement
www.aeroplusrc.com
If required install a servo extension lead onto the servo, remember to use a servo plug clip.
Fit the servo and centre the servo arm.
Using the pushrod supplied screw ball joints onto each end. The correct length will leave the aileron lined up to the inner part still attached to the
wing.
Using supplied bolts attach the pushrod at both ends. Check to see you have sufficient movement of the aileron. If not adjust.
Carry out the same procedure on the other wing.
Electric
Assemble the supplied electric motor box and bolt to the engine bulkhead.
Depending on the length of your motor you may need to use the supplied round plywood spacers to achieve the correct length for the motor.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
