Advertisement
www.aeroplusrc.com
Test fit the joiner bar
Iron back down the covering
Cover the joiner bar leaving the glue area exposed
Cut the area for the joiner bar on the other elevator half, iron down the covering and test fit.
Glue the joiner bar into 1 of the elevator halves with epoxy.
Now we can hinge one of the elevators with the joiner bar glued in.
Apply 'vaseline' to the hinge point on the hinges and using 30 minute epoxy to glue these into the both the stab and elevator half. Wipe off excess
glue before it sets.
Dry fit the other elevator half with the hinges and make sure that both halves align to the stab. Trim where the joiner bar sits if required.
Glue the hinges in both stab and elevator again with 30 minute epoxy. While gluing use tape to keep it in alignment
Completed elevator
Remove the covering for the elevator servo
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
