BENDIXKing KLN 94 Installation Manual page 76

B
There are only two combinations allowed. The choices are shown below.
MNT 5 Page Format
Annun:
If the KLN94 is meant to replace an existing KLN89B and there is already an installation with
external annunciators that display "APR ARM" and "APR ACTV", then the same combination
must be chosen in the MNT 6 page in order to have conformity throughout the aircraft. This will
also allow the installer to keep the existing external annunciators and switches in place.
In a new KLN 94 installation, the external annunciators may not be required. In this case, the user
may prefer "choice 2" since it is shorter and more descriptive.
2.4.1.7 Maintenance 7 (MNT 7) Page
The MNT 7 page allows the installer to select between the Standard RS232 Serial Output and
the Enhanced RS232 Serial Output. The Enhanced RS232 bus will only work with the
Bendix/King Skyforce KMD550 Multifunctional Display, at the time of publication of this manual.
In an installation of the KLN94 with a KMD550 also has additional moving map equipment, the
standard RS232 should be chosen, as it will be able to drive a minimal subset of labels in the
KMD550 as well as additional equipment.
If you see no published interconnect for your MFD or Moving Map Display, consult the
manufacturer for installation information.
2.4.1.8 Maintenace 8 (MNT 8) Page
A Configuring the KLN 94 to operate without roll steering.
1. Select MNT 8 page.
2. Push CRSR button. The cursor will appear over the second line.
3. Select "None" and push CRSR again. The screen should look like:
Rev. 4, Jan/2003
Choice 1
APR ARM
APR ACTV
Configuration DC Roll Steering
Module None
MNT 8
10599I04.CDL
Choice 2 Default Settings
TERM APR ARM
APR APR ACTV
KLN 94
Page 2-72