Table of Contents
Advertisement
B
ROLL STEERING LO
FCS LOC ENG:
LATERAL DEV FLAG +:
LATERAL DEV FLAG -:
VERTICAL DEV FLAG +:
VERTICAL DEV FLAG -:
LATERAL SUPERFLAG:
VERTICAL SUPERFLAG:
LATERAL DEV +L:
LATERAL DEV +R-:
VERTICAL DEV +UP:
VERTICAL DEV +DOWN:
OBS OUT:
+TO / +FROM Flag Outputs:
To Indication:
From Indication:
ALTITUDE ALERT ANNUNCIATE:
ALT ALERT AUDIO:
Rev. 4, Jan/2003
This is an output. It is always grounded
OPEN = Inactive
LOW = Active (Output can sink up to 250 mA)
Valid: 350 to 900 mV (high)
≤
Flag in view:
50mV (low)
Output is capable of driving five 1k ohm parallel
loads.
Reserved for future use.
≥
Valid =
18 V in 28 VDC installations;
14 VDC installations. Invalid =
installations while sinking 1 mA. Output can
source at least 250 mA.
Reserved for future use.
These outputs are differential pairs (+L and
+UP are positive). Output range is
and is capable of driving five 1k ohm parallel
loads.
Reserved for future use.
Used to excite the OBS resolver rotor. Nominal
output frequency = 450 Hz. Nominal unloaded
peak amplitude = 6 V. Output drive capability =
40 mA.
+100 to +900 mV on +TO with respect to
+FROM when desired course is within
the bearing to the active waypoint.
-100 to -900 mV on +TO with respect to
+FROM when desired course is within 180
±
°
85
with respect to the bearing of the active
waypoint. Outputs are capable of driving up to
five 200 ohm parallel loads.
HIGH = Inactive
LOW = Active (can sink up to 250 mA)
This output is active whenever ALTITUDE
ALERT ANNUNCIATE is active, Signal is 1Khz,
3.5 Vrms max into 500 ohms. Refer to
Paragraph 2.4.4.9
for the procedure to adjust
the volume.
10599I04.CDL
KLN 94
≥
10 V in
≤
3.5 V in all
±
300 mV
±
°
85
of
Page 1-4
Hide quick links:
Advertisement
Table of Contents
