Finishing Commissioning - Worcester GREENSTAR 12i Instruction Manual

A
A
B
C
C
36

FINISHING COMMISSIONING

B
A
C
E
INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER GREENSTAR 12i/24i System
FINISHING COMMISSIONING
The boiler has been factory set, so there should
be no need to adjust any controls.
REPLACE OUTER CASING:
1 Replace outer casing making sure that the
securing points are properly located.
Replace top two screws (A).
Re-tighten bottom two screws (B).
2. FITTING FASCIA FLAP:
Present the flap up to the appliance with the hinge
pins facing the appliance.
Engage the left hand pin into the grey pivot.
The hinge pin and pivot hole are both square,
rotate the flap to ensure that the pin is located in
the pivot.
Support the flap in your left hand and with your
right hand, bend the right side down. This should
enable you to engage the right hand pin in the
pivot. Rotate the flap to ensure that the pins and
pivots are located securely.
Close the flap.
INSTALLING BOTTOM PANEL:
3 The bottom panel slides onto two ledges
(C) either side of the boiler frame.
Hold the panel up against the underside of
the boiler and slide towards the rear until it
is fully engaged.
NOTE: Every time the power to the
HANDOVER:
Complete the Benchmark Gas Boiler
Commissioning Checklist.
NOTE: The Benchmark Checklist can be found
at the rear of these instructions.
Open the facia cover by gently pressing the
C
centre top of the cover (D).
Set up the controls and show the user how
to operate all the controls shown in the User
Guide.
Place the user guide into the tray (E) on the
inside of the facia cover.
If the appliance is unused and exposed to
freezing conditions, shut off all the mains
supplies and drain the system and boiler.
D
8 716 115 167b (03/2009)
appliance is turned off and on, the
appliance enters a learning mode
and may take some time to
optimise the boiler performance.
This time is variable and is
dependant on hot water and
central heating demand.