Hangar 9 P-47 Thunderbolt Assembly Manual page 24

Section 10: Two-Stroke Engine Installation

Step 3
Center the engine mount in relationship to the oval holes
in the firewall. Tighten the bolts holding the mount to
the firewall. (Remember to make sure the barbs on the
blind nuts go into the backside of the firewall.) Test fit the
throttle pushrod tube into the fuselage. Once satisfied with
the fit, roughen the tube using medium sandpaper. Slide
the tube back into position and use medium CA to glue it
to the firewall.
24

Step 4
Position the throttle servo tray so the opening for the
servo is on the same side of the fuselage as the
throttle pushrod tube. Use Medium CA to glue the
tray into position.

Step 5
Attach the "Z" bend on the throttle pushrod wire onto the
carburetor arm. Slide the pushrod wire into the tube.