Hangar 9 P-47 Thunderbolt Assembly Manual page 19


Step 3
Locate the retract servo tray. Use 6-minute epoxy to glue
the servo tray into position.

Step 4
Install a low profile retract servo in the servo tray using
the hardware provided with the servo. Prevent splitting
the servo tray by drilling 1/16" holes for the servo
mounting screws.

Step 5
Select a servo arm from those included with your servo
that has a distance of 7/8" to 1" between equally spaced
holes as shown to start with.
Section 8: Retract Linkage Installation

Step 6
Use a 5/64" drill bit to drill the appropriate holes in
the arm. Attach two quick connectors to the servo arm
using quick connector washers and retainers.

Step 7
Connect the retract servo to your radio system and
electronically move the servo to the retracted position.
Slide the retract control wires through the quick
connectors as shown and secure the servo arm to
the retract servo.
19