Inner Control Access Panel; Bin Trim Ring; Upper Cabinet Face Plate & Bin Seal; Decor Trim Gasket - Sub-Zero 315I Technical Service And Parts Manual

Model 315I (UC Ice Maker)
Inner Control Access Panel Removal
The inner control access panel is behind the control
panel assembly. The access panel is held in place with
three screws that pass through the panel into the unit
cabinet/shell, one at top center of the panel and one at
each side.
To remove the inner control access panel, the control
knob and control panel assembly must first be removed.
Then, extract the three panel mounting screws and pull
the top of the panel forward while lifting up. (See
Figure 5-7)
Bin Trim Ring Removal
The bin trim ring fits into the opening of the upper cabi-
net face plate and extends into the bin area. Tabs
behind the outer flange on the trim ring hold the ring to
the upper cabinet face plate, and a bead of permagum
is placed behind the outer flange of the trim ring to pre-
vent it from rattling.
To remove the bin trim ring, flex it inward at the top and
sides while pulling forward, this will disengage the tabs
from the upper cabinet face plate. (See Figure 5-8)
Upper Cabinet Face Plate & Bin Seal Removal
The bin seal is a 3/4" thick styrofoam sheet cut to
approximately the same size and shape as the upper
cabinet face plate. The bin seal is sandwiched between
the face plate and the cabinet.
The upper cabinet face plate is attached to the cabinet
with screws: two screws pass through the top hinge and
the face plate into the top hinge mount support bracket;
two screws pass through the face plate at the upper
corner on the handle side and one screw at each bot-
tom corner pass through flanges into the cabinet/shell.
To remove the upper cabinet face plate and bin seal,
the control panel assembly, door, hinges and bin trim
ring must be removed first. Then, extract the two
screws at the upper corner on the handle side and the
two screws at each bottom corner. Now, pull the face
plate and bin seal forward. (See Figure 5-8)
Decor Trim Gasket Removal
The decor trim gasket fits over the edge of the
cabinet/shell at the opening of the bin. A screw at the
top of the opening and one at the bottom of the opening
help to hold the gasket in place.
To remove the decor trim gasket, the control panel
assembly, door, top hinge, bin trim ring, upper cabinet
face plate and bin seal must be removed first. Then,
loosen the screws at top and bottom center of the bin
opening and pull the gasket from the edge of the cabi-
net/shell. (See Figure 5-9)
Component Access/Removal
Figure 5-7. Inner Control Access Panel Removal
Upper Cabinet Face Plate
Figure 5-8. Bin Trim Ring,
Upper Cabinet Face Plate and Bin Seal Removal
Loosen
these
screws
Figure 5-9. Decor Trim Gasket Removal
5-5
#3757320 - Revision B - August, 2005
Access
Panel
Top Hinge Mount
Support Bracket
Bin Seal
Bin Trim
Ring
Decor
Trim
Gasket