Exterior Components; Kickplate; Door Gasket - Sub-Zero 315I Technical Service And Parts Manual

Model 315I (UC Ice Maker)

EXTERIOR COMPONENTS

Kickplate Removal
The kickplate is held in place with two screws, one at
each side. To remove the kickplate, extract the screws
and pull the kickplate forward. (See Figure 5-1)
Door Panel Mounting Hardware and Upper
Door/Hinge Cover Removal
The handle-side panel mounting bracket is attached to
the back side of the door panel with screws. The tabs
of the handle-side bracket then fit into slots in the face
of the door. The top and bottom panel mounting brack-
ets are held to the front of the door with screws. The
panel is secured to the top and bottom brackets by
screws that pass through the brackets into the back of
the panel. The upper door/hinge cover is also mounted
to the face of the door with screws.
To access these components, the door panel will need
to be removed. Begin by opening the door and extract-
ing the door panel mounting screws from the bottom
and top brackets. Then, slide the panel towards the
hinge side to disengage the handle-side bracket from
the slots in the door.
With the door panel off, remove the top and bottom
panel mounting brackets and the upper door/hinge
cover by extracting their mounting screws from the face
of the door. Remove the handle-side bracket from the
back of the door panel by extracting the panel mounting
screws. (See Figure 5-2)
Door Gasket Removal
The door gasket has a rib on its back side that fits into
a channel in the door liner. To remove the door gasket,
open the door and pull the gasket from the door liner.
(See Figure 5-3)
Component Access/Removal
Figure 5-1. Kickplate Removal
Bottom Bracket
Handle-Side Bracket
Figure 5-2. Panel Mount Hardware
& Upper Door/Hinge Cover Removal
Figure 5-3. Door Gasket Removal
5-3
#3757320 - Revision B - August, 2005
Door/Hinge
Cover

Door Gasket

Kickplate

Top
Bracket