Door; Hinge; Bin Thermostat Control Knob; Control Panel Assembly - Sub-Zero 315I Technical Service And Parts Manual

Component Access/Removal
Door Removal
The door is held in place by screws that pass through
the top and bottom hinges into the face of the door. To
remove the door, the door panel will need to be
removed first. With the door closed, extract the door
mounting screws from the top and bottom hinges (two
each hinge) and pull the door from the unit. (See
Figure 5-4)
NOTE: To remove the door with the hinges, see Hinge
Removal below.
Hinge Removal
Two screws at each hinge secure the hinges to the unit.
To remove the hinges, open them fully and extract the
hinge mounting screws. (See Figure 5-5)
Bin Thermostat Control Knob Removal
The bin thermostat control knob fits over the shaft of the
bin thermostat. To remove the knob, pull it straight for-
ward off of the control shaft. (See Figure 5-6)
Control Panel Assembly Removal
The control panel assembly has a flange at the bottom
that sits behind the lower cabinet face plate. Adhered
to the top rear of the control panel are two halves of
dual lock fastener pads (similar to velcro) which mate
up with the other halves of the dual lock fastener pads
adhered to the bottom flanges of the upper cabinet face
plate.
To remove the control panel assembly, the bin thermo-
stat control knob needs to be removed first. Then pull
the top of the control panel forward to disengage the
dual lock fastener pads and lift the panel up. (See
Figure 5-6)
#3757320 - Revision B - August, 2005
Model 315I (UC Ice Maker)
Figure 5-4. Door Removal
Figure 5-5. Hinge Removal
Figure 5-6. Control Knob and Panel Removal
5-4

Door

Mounting
Screws

Hinge

Hinge
Mounting
Screws
Hinge
Control
Panel
Control
Knob