Bin Level Control; Cube Size Control - Sub-Zero 315I Technical Service And Parts Manual

Hide thumbs Also See for 315I:

Service manual (9 pages)

Technical service and parts manual (8 pages)

Planning information (5 pages)

Table Of Contents

Table of Contents

Model 315I (UC Ice Maker)

Bin Level Control (Thermostat) Removal

The bin level control is mounted to the right side of the

control box face plate with screws. Two wires are con-

nected to the back of the control. The control capillary

tube is inserted into a plastic sleeve and routed out the

back of the control box, up through a grommet in the

base assembly, up the back of the bin assembly and

into the back of the cylindrical bin thermostat bracket.

To access the bin level control, remove the control

panel, inner access panel and back panel.

Before removing the bin level control, disconnect the

power to the unit. Then, extract the control box face

plate mounting screw and pull the face plate forward.

Extract the control mounting screws. Disconnect the

electrical leads from the control. At the back of the unit,

pull the control capillary tube from the thermostat brack-

et, then pull the capillary tube with the sleave from the

grommet in the base assembly. At the front of the unit,

pull the control body, capillary tube and sleeve forward,

out of the control box. (See Figure 5-23)

Cube Size Control (Evap. Thermostat) Removal

The cube size control is mounted to the left side of the

control box face plate with screws. Three wires are

connected to the back of the control. The control capil-

lary tube is routed out the back of the control box, up

through a grommet in the base assembly, up the back

of the bin assembly, then inserted into a tube attached

to the evaporator.

To access the cube size control, remove the control

panel, inner access panel, upper and lower face plates,

back panel, unit shell, insulation bag, tube retaining clip

and evaporator/platen cover.

Before removing the cube size control, disconnect the

power to the unit. Then, extract the control box face

plate mounting screw and pull the face plate forward.

Extract the control mounting screws. Disconnect the

electrical leads from the control. At the back of the unit,

pull the control capillary tube from the tube on the evap-

orator, then pull the capillary tube from the grommet in

the base assembly. At the front of the unit, pull the con-

trol body and capillary tube forward, out of the control

box. (See Figure 5-24)

Component Access/Removal