Custom Panel - Sub-Zero UC-15I Installation Manual

IN S TA L L AT I O N

Custom Panel

O VER L AY PA NE L
For overlay applications, a custom door panel must be
installed. Panel size is critical for a proper fit. To verify panel
requirements and dimensions, refer to the Sub-Zero design
guide at subzero.com/specs.
Finish all sides of the custom panel. They will be visible
when the door is open.
A D-style handle is recommended. The door handle must be
located near the edge of the panel opposite the hinge, cen-
tered top to bottom. Stainless steel tubular and pro handles
are avail able through an authorized Sub-Zero dealer. For
local dealer information, visit the find a showroom section
of our website, subzero.com.
|
10 Sub-Zero Customer Care 800.222.7820
PAN EL IN STAL LATIO N
Remove the handle side bracket attached to the front of the
door. Place the custom overlay door panel face down on a
protected work surface. On the back of the panel, position
the plastic template provided, flush with the top and side
edges. Verify proper location for right-hand (RH) or left-hand
(LH) door swing. Refer to the illustration below.
Mark the holes, remove the template and drill pilot holes for
the brackets. Position and secure the mounting bracket with
screws provided.
To install the custom door panel, partially insert a screw in
the center of each mounting position on the hinge side of
the door. Engage the tabbed bracket to the handle side
of the door, then slide the hinge side mounting bracket onto
positioning screws. Slotted holes on the mounting bracket
should slide under screw heads to support the panel. Refer
to the illustration below. Panel can be adjusted
and down and side to side.
Once the custom panel is in place and properly adjusted,
attach remaining screws to the hinge side mounting bracket
and install hinge covers.
Template position.
1
/ " up
(6)
4
DOOR
PANEL
BRACKET
SCREW
CAP
Panel installation.