Kickplate/Grille Adjustment; Reversing Door Swing - Sub-Zero 315I Technical Service And Parts Manual

Installation Information

Kickplate/Grille Adjustment

The Kickplate/Grille can be adjusted up or down to
complete the built-in design. To adjust the grille, loosen
the two mounting screws and move the kickplate/grille
up or down to the desired location, then retighten the
screws. (See Figure 2-5)
Airflow through the kickplate/grille must never be
obstructed. Doing so could cause damage to the ice
machine.

Reversing Door Swing

All model 315I units are manufactured with the hinges
on the right side of the door. The door and hinges are
designed to be reversible, so that the hinges can be
moved to the left side of the door. To reverse the door
swing from right to left, follow the instructions below:
1. Remove door panel (if previously installed).
2. Remove door/hinge cover (top hinge-RH) from top
of door by extracting the two mounting screws from
face of door. (See Figure 2-7)
3. Remove door from hinges by extracting the four
door mounting screws, two at bottom hinge, two at
top hinge. (See Figure 2-7)
4. Remove hinges from cabinet by extracting the four
hinge mounting screws, two each hinge.
5. Extract the four filler screws from opposite (left)
hinge mounting holes in cabinet (See Figure 2-7)
and insert them into right-hand hinge mounting
holes of cabinet.
6. Move bottom right hinge to top left hinge mounting
holes and insert two hinge mounting screws
through hinge into mounting holes and tighten.
Then, move top right hinge to bottom left hinge
mounting holes and insert two hinge mounting
screws through hinge into mounting holes and tight-
en.
7. Attach door to hinges with door mounting screws,
utilizing left-hand door mounting holes.
NOTE: Do not flip door.
8. Extract two screws which secure upper door panel
mount bracket to top right of door, then reattach
bracket to top left of door utilizing left-hand mount-
ing holes. (See Figure 2-7)
9. Attach new hinge cover (top hinge-LH) to top of
door using the two mounting screws removed in
step 2 above.
10. Open and close door to check for proper operation.
#3757320 - Revision B - August, 2005
Model 315I (UC Ice Maker)
Figure 2-6. Kickplate/Grille Adjustment
Hinge
Mounting
Holes
Component Removal for Door Swing Reversal
2-6
Door
Mounting
Screws
Door/Hinge
Cover
Door
Mounting
Screws
Figure 2-7.
Upper
Door
Panel
Bracket