Leveling; Securing The Ice Machine; Side Panels; Reversing The Door Swing - Sub-Zero UC-15I Service Manual

Model UC-15I (Undercounter Ice Machine)

LEVELING

1. Adjust the levelers close to desired height.
2. Move the bin into its final position.
3. Level the ice machine to assure that the bin door
closes and seals properly. Use a level on top of the
bin. Turn the base of each foot as necessary to
level the bin. Refer to the illustration below.
Turn Clockwise
to Lower Unit
Adjusting Leveling Leg
SECURE THE ICE MACHINE
To secure the ice machine, install two #8 x 1/2" flat
head screws through each hinge. Refer to the illustra-
tion below.
NOTE: If the door swing is to be changed, refer to
Reversing the Door Swing before securing the unit.
Secure Ice Machine to Cabinets
Flat Head
Screws

SIDE PANELS

With the Sub-Zero ice machine, the side panels must
be securely fastened to the adjacent cabinets and floor.
Panels should be fastened to the floor and walls using
'L' brackets (hardware not provided). To help move the
unit into place, rout out an area in the floor so the 'L'
bracket will sit flush with the floor level. Brackets and
screws are provided for mounting the unit to adjoining
cabinets and side panels.

REVERSING THE DOOR SWING

The hinged side of the door may be reversed to the
other side if desired. The Sub-Zero ice machine is
shipped with the door hinged at the right. The door and
hinges are designed for placing the hinges on either
the right or the left side of the unit. Moving the hinges
to the left in the pre-drilled holes, allows the door to
pivot from the left side. Refer to the illustrations below.
NOTE: The plastic molding which covers the top area
of the door, packaged with the ice machine, is required
for this procedure.
1. To begin, remove the four screws that secure the
door hinges to the ice machine. Refer to the illus-
tration below.
NOTE: Remove the shim located between the cab-
inet and bottom hinge, this shim will transfer to the
left side bottom hinge.
Step 1
(CONTINUED ON NEXT PAGE)
2-9
Installation Information
Remove Door
#7012423 - Revision A - August, 2009