Technical Specifications - Windsor QK32 Operating Instructions Manual

TECHNICAL SPECIFICATIONS

ITEM
Normal Power
Rated Voltage
Rated Amperage
Batteries
Scrub Brush Motors
Vacuum Motors
Propelling Motor
Mass (GVW)
Weight empty without batteries
Solution Control
Solution tank capacity
Recovery tank capacity
Scrub brush
Scrub brush pressure
Scrub brush speed
Tires (QK32)
(QQK32)
Foundation Pressure (at recommended tire psi)
Maximum Speed
Coverage
Frame construction
Brakes
Minimum aisle u-turn width
Steering
Ramp climbing
Height
Length
Length
Width without squeegee
Width with squeegee
Width of scrub path
The sound pressure level at the operators ear
was measured to be 73 dBA. This was a
nearfield, broad-band measurement taken in a
typical commercial environment on a tile floor .
This appliance contains no possible source of
impact noise. The instantaneous sound
pressure level is below 63 Pa.
3-1
LENGTH
QUICK 98560 03/17/01
DIMENSION/CAPACITY
2.8 kW
24 VDC
115 amps
4 x 6 volt 250-250 A/H
2 x .75 hp (0.56 kW)
1 x .75 hp (0.56 kW) Standard, second motor optional
.75 hp (0.56 kW)
1780 lbs. (810 kg)
810 (302 kg)
Gravity feed, fully variable with automatic shut off in neutral.
30 gal. (113.5 liter)
30 gal. (113.5 liter)
2 dia. X 16 in. (5 cm x 40.5 cm)
0-150 lbs. (0-68 kg) 4 automatic pressure settings
200 rpm
12 in. (30.5 cm) pneumatic non-marking standard
12 in. (30.5 cm) Black Knobby Foam Fill
35 lbs/in.²
3.7 miles/hour (5.95 km/hour)
46,200 ft² /hour @ 3.5 mph with 2 in. overlap
Welded cold rolled steel and steel plated
Self centering mechanical 8 in. (20.3 cm) disc with hand lock
parking brake.
66 in (168 cm)
Rack and Pinon
7.5 degrees
53 in. (135 cm)
61 in.(155 cm) without counterweighed bumper
64 in. (163 cm) with counterweighted bumper
37.75 (96 cm)
41 in (104 cm)
32 in. (81 cm)
WIDTH
The weighted root mean square acceleration at
the operator's arms was measured to be below
2.5 m/s² . This was a tri-axial, third-octive band
measurement made during normal operation on
a composite tile floor. The measurement and
related calculations were made in accordance
with ANSI S3.34-1986.
HEIGHT