Windsor QK32 Operating Instructions Manual page 13

MACHINE OPERATION
SCRUBBING WITH THE QUICK©
Plan the scrubbing pattern in advance. The longest
track is around the perimeter of the area to be
cleaned. For efficient operation, the runs should be
the longest possible without turning, stopping, or
raising and lowering scrub deck/squeegee. Overlap
the bush paths and avoid transporting over
previously cleaned areas.
The QUICK© will automatically raise the squeegee
slightly when reverse travel is selected. If the
machine is allowed to stand in neutral with the scrub
head down for more than 2 seconds, brush motors
stop, solution flow stops, and the scrub deck will
raise slightly. If either forward or reverse travel is
selected, the scrub head will lower to the preset
position and solution flow will continue in the same
settings once movement begins.
NOTE: In order to achieve the best possible results,
the area which is to be cleaned should be swept
before scrubbing. Large debris, strings, wire must
be removed to prevent being caught in brushes or
squeegee.
3-9
TO BEGIN SCRUBBING
The QUICK© uses a one touch system for turning
on the brushes and vacuum motor and lowering both
to the operating position.
! CAUTION
When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
! WARNING
Flammable liquids and/or reactive metals can
cause explosions or fire! Do not pick up.
1. Place left foot on brake pedal or make sure
parking brake has been set.
2. With directional pedal in neutral turn key switch
to "ON".
3. Release brake.
4. Press directional pedal to travel in the desired
direction and steer to the start of the scrub
pattern.
5. Press the brush switch (#1) on the console
touch pad. The vacuum motors will switch on,
the LED will light, and the squeegee will lower to
the floor. The brush motors will start, the scrub
deck will lower to the light scrub position, and
the solution will begin. Three set of LED's (one
set of four lights indicating amount of brush
pressure, one light for brush motor on, and one
light for vacuum motor on/squeegee down will all
light. The brush light will blink until the selected
pressure is attained.
NOTE: Shut machine off immediately if water or
foam is expelled from the machine.
6. To double scrub touch the squeegee switch and
the squeegee will raise.
7. Adjust the brush pressure by touching switch on
the touch pad.
8. Adjust the solution valve with lever. Solution will
not flow to the floor until the scrub deck is
activated.
9. Adjust ground speed and solution flow to suit
cleaning conditions.
NOTE: Once solution flow rate is set it is not
necessary to shut off solution when stopping
scrubbing. Solution flow is automatically shut off
when brush motors stop. When bush motors are
turned on, flow automatically resumes.
QUICK 98560 09/20/99