Measuring Procedure - Microlife BP3NQ1-4X Instruction Manual

Comment:
If it is not possible to fit the cuff to your left arm, it can
also be placed on your right arm. However, all measure-
ments should be made using the same arm.
Comparable blood pressure measurements always
require the same conditions (Relax for several minutes
before taking a measurement).

5.4. Measuring procedure

fter the cuff has been appropriately positioned on the
arm and connected to the blood pressure monitor, the
measurement can begin:
a) Press the ST RT/STOP button. The pump
begins to inflate the cuff. In the display, the
increasing cuff pressure is continually displayed.
b) fter automatically reaching an individual pressure,
the pump stops and the pressure slowly falls. The
cuff pressure is displayed during the measurement.
c) When the device has detected your pulse, the heart
symbol in the display begins to blink.
d) When the measurement has been concluded, a long
beep tone sounds. The measured systolic and dias-
tolic blood pressure values, as well as the pulse are
now displayed.
e) The appearance of this symbol
irregular heartbeat was detected. This indicator is
only a caution. It is important that you be relaxed,
remain still and do not talk during measurements.
NOTE: We recommend contacting your physician if
you see this
f) The measurement results are displayed until you
switch the device off. If no button is pressed for 1
minute, the device switches off automatically.
10
signifies that an
indicator frequently.
Cuff on
right arm
Pumping
Pressure
Measuring
Systolic
Diastolic
Pulse
Measurement
complete