Kubota WSM L3540-II Workshop Manual page 510

L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
HST Range Gear Shift Lever Sensor: for HST Model
This sensor (1) is designed to detect the position at
which the HST range gear shift lever changes the speed,
and is mounted at the bottom of the lever.
It has the variable resistor of revolution angle type,
and the maximum resistance value is approximately
5.4 kΩ. It outputs the lever position of L, M, N or H in the
range of approximately 0.3 to 4.6 V.
(1) HST Range Gear Shift Lever
Sensor
HST Pedal Sensor: for HST Model
The HST pedal sensor is located on the right of the
HST pedal. When the HST pedal is operated, signals are
sent to the ECU.
(1) HST Pedal Sensor
Cruise Control Lever Position Sensor: for HST
Model
The cruise control lever position sensor is located
under the cruise control lever. When the cruise control
lever is operated, signals are sent to the ECU.
When the cruise control lever is operated, a lamp
lights up on the panel.
(1) Cruise Control Switch
Clutch Pedal Switch: for HST Model
This switch (1) is mounted close to the fulcrum of the
clutch pedal, and is turned on when the pedal is
depressed (clutch "OFF"). It serves as a safety switch
when the engine is started.
(1) Clutch Pedal Switch
9-M13
ELECTRICAL SYSTEM
9Y1211167ELM0029US0
9Y1211167ELM0030US0
9Y1211167ELM0031US0
(2) Clutch Pedal
9Y1211167ELM0032US0
KiSC issued 02, 2015 A