Kubota WSM L3540-II Workshop Manual page 147

L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
(Continued)
(When reassembling)
• Using the governor spring hooking special tool (1), Hook the
small spring (4) first and then the large governor spring (2) on
the speed control plate (6).
• Put the governor spring hooking special tool (1) from the
injection pump side to catch the large governor spring (2). Keep
this spring slightly extended and place the speed control plate
(6) in its specified position.
• Using the governor spring hooking special tool (1), hook the
small governor spring onto the fork lever (3).
NOTE
• Be careful not to stretch the small governor spring too long
because otherwise it may get deformed permanently.
• Using the governor spring hooking special tool (1), hook
the large governor spring (2) onto the fork lever (3).
• Make sure both the governor springs (2), (4) are tight on the
fork lever (3).
• Apply and tighten up the two bolts and two nuts on the
speed control plate (6).
• Check that the speed control lever (5) positions low idle,
after assembling governor springs.
• Check that the speed control lever (5) returns to the high
idle position rather than the low idle position, after moving
the lever to the maximum speed position.
• Finally attach the injection pump cover in position.
(1) Governor Spring Hooking Special
Tool
(2) Large Governor Spring
(3) Fork Lever
1-S45
ENGINE
(4) Small Governor Spring
(5) Speed Control Lever
(6) Speed Control Plate
9Y1211167ENS0038US0
KiSC issued 02, 2015 A