Kubota WSM L3540-II Workshop Manual page 564

L3540-II, L4240-II, L5040-II, L5240-II, L5740-II , WSM
(Continued)
6. "STEP-01" is displayed (d): Follow the procedures as follows.
• Cruise control lever: Set the "Maximum forward position".
• HST response dial: Set the "Maximum fast position".
• HST pedal: Keep the "Maximum forward position".
7. "STEP-02" is displayed (e): After completing the above 6,
"STEP-02" is displayed. Then proceed to the next step.
NOTE
• When "ERROR-xx" is displayed (l) refer to the below chart.
8. "PUSH-SW" is displayed (f): Hold down the displayed mode
switch for more than 2 seconds.
9. "STEP-03" is displayed (g): Follow the procedures as follows.
• Cruise control lever: Set the "Neutral position".
• HST response dial: Set the "Maximum slow position".
• HST pedal: Keep the "Maximum reverse position".
10. "STEP-04" is displayed (h): After completing the above 9,
"STEP-04" is displayed. Then proceed to the next step.
NOTE
• When "ERROR-xx" (m) refers to the below chart.
11. "PUSH-SW" is displayed (i): Hold down the displayed mode
switch for more than 2 seconds.
12. "OK" is displayed (j): The setting has been preserved correctly
to the ECU.
13. Turn off the key.
(Reference)
Error Display
ERROR-71
ERROR-72
ERROR-73
ERROR-74
ERROR-75
ERROR-76
(a) Mode Selection Display
(b) Information Display
(c) Setting Display-1
(d) Adjusting Display-1
(e) Setting Display-2
(f) Adjusting Display-2
(g) Setting Display-3
9-S31
ELECTRICAL SYSTEM
Fine-adjustment
Range Gear Shift Sensor
HST Pedal Sensor
Swashplate Position Sensor
Cruise Control Lever Position Sensor
Throttle Lever Sensor
HST Response Dial
(h) Setting Display-4
(i) Adjusting Display-3
(j) Correct Preserving Display
(k) Error Display-1
(l) Error Display-2
(m) Error Display-3
9Y1211167ELS0027US0
KiSC issued 02, 2015 A