Transistor Hfe Measurement - Tenma 72-8150 Operating Manual

Model 72-8150: OPERATING MANUAL
D. Transistor hFE Measurement (see figure 6)
To measure transistor, set up the Meter as follows:
1.
Check that the transistor is PNP or NPN type.
2. Insert the transistor to be measured to the corresponding
Transistor Jack.
3.
The Meter displays the tested transistor's nearest value.
Note
l
When transistor measurement has been completed,
disconnect the connection between the test clips and
the circuit under test and remove them from the input
terminals of the Meter.
NPN
PNP
hFE
(figure 6)
17