Makita 2414NB Instruction Manual page 5

Interval between vise and guide plate
4
003758
The original spacing or interval between the vise and the
guide plate is 0 - 170 mm. If your work requires wider
spacing or interval, proceed as follows to change the
spacing or interval.
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure
it using the hex bolts. The following interval settings are
possible:
35 - 205 mm
70 - 240 mm
003759
CAUTION:
Remember that narrow workpieces may not be
•
secured safely when using the two, wider interval
settings.
Setting for desired cutting angle
3
003760
To change the cutting angle, loosen the two hex bolts
which secure the guide plate. Move the guide plate to
the desired angle (0° - 45°) and tighten the hex bolts
securely.
1. Socket wrench
1
2. Guide plate
2
3. Move
4. Hex bolts
3
1. Socket wrench
1
2. Guide plate
2
3. Hex bolts
CAUTION:
Never perform miter cuts when the guide plate is
•
set at the 35 - 205 mm or 70 - 240 mm position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Removing or installing cut-off wheel
1
003761
To remove the wheel, raise the safety guard. Press the
shaft lock so that the wheel cannot revolve and use the
socket wrench to loosen the hex bolt by turning it
counterclockwise. Then remove the hex bolt, outer
flange and wheel. (Note: Do not remove the inner flange,
ring and O-ring.)
To install the wheel, follow the removal procedures in
reverse.
1
2
3
4
003762
CAUTION:
Be sure to tighten the hex bolt securely. Insufficient
•
tightening of the hex bolt may result in severe injury.
Use the socket wrench provided to help assure
proper tightening.
Always use only the proper inner and outer flanges
•
which are provided with this tool.
Always lower the safety guard after replacing the
•
wheel.
5
2
1. Shaft lock
2. Safety guard
3
3. Socket wrench
1. O-ring
7
2. Inner flange
3. Ring
4. Spindle
5. Cut-off wheel
6. Outer flange
7. Hex bolt
6
5