Coolant connection
WARNING!
Tighten all hose clamps to 2.0 + 0.5 Nm.
Any coolant running off should be collected using an appropriate container!
Install hoses so that they are kink-free. Unless specified otherwise, always fasten using cable ties.
Position hose clamps and spring band clamps so that no other hose can be damaged.
The connection should be "inline" based on the following diagram:
B
All clamps without a specific designation are 20-27 mm dia. hose clamps
C
A
Motor
Fiat Grande Punto
Heat
exchanger
Coolant
routing
diagram
14