Loading Pellets; Starting The Heater For The First Time; Curing The Paint - Travis Industries AGP FS Manual

22

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper.
NOTE: If the hopper lid is opened for more than 1 minute, the stove will enter a shutdown cycle. If
this happens, simply restart the stove.
WARNING: The stovetop becomes hot during operation. Make sure to keep any flammable items
(bag of pellets) away from the top while reloading.

Starting the Heater for the First Time

Start the Heater - Let it Burn for 1 Hour - THEN OPEN THE DOOR.
The stove paint is cured through heat. To prevent it from bonding to the door gasket, you must burn
the heater for approximately 1 hour, then open and close the door to break any bonding.

Curing the Paint

This stove uses heat-activated paint that will
emit some fumes while starting the first fire.
Open doors and windows to the room to vent
these fumes. You may also notice oil burning
off of the interior of the stove. This rust-
stopping agent will soon dissipate. Allow 48
hours for the paint to cure.
© Travis Industries
Operation
NOTE: The stove will not run if the lid is open.
4/11/22- 1566
Allow 48 hours
2 to 4 hours
AGP Stove