Travis Industries heritage bay Owner's Manual page 16

F
INALIZING THE
P 16
AGE
d Follow the directions below to install the burner pan and attach the piezo igniter wire.
d
Install the burner pan, tilting the
burner forward to allow the gas
control valve to insert without
damage.
e
Use the six nuts
included with the kit to
attach the burner pan.
7/16Ó
Socket
Piezo Igniter
b
Attach the orange wire
from the burner pan to
the piezo igniter.
a
e Attach the brown and red wires from the on/off switch to the gas control valve.
f Replace the control cover removed in step 1.
I
NSTALLATION
Route the brown and red
wires to the front (these wires
are from the on/off switch).
Gas Control Valve
PILOT ADJ
( .)
CONT
- For Qualified Installers Only!
Burner Pan
Gas Control Valve
Attach the flex tube (included with the
owner's pack) to the gas inlet and bend
it so it lines up with the inlet on the gas
control valve.
Brown Wire
Red Thermopile Wire
(leave attached)
White Thermopile Wire
(leave attached)
c
Tilt the front of the burner
so it tucks under this
ledge while installing.
Red Wire