Mitel MIVOICE OFFICE 250 User Manual page 14

Directory
Display Outside Party Name
On/Off
Display Time and Date
Do-Not-Disturb
Do-Not-Disturb On/Off
Handsfree On/Off
Message
Message – Cancel
Message – Cancel Current
Message – Silent
Microphone Mute – On/Off
Page
Page Receive – On/Off
Program Buttons
Redirect Call
outside parties.
307 Allows display phones users to search for extension
numbers of System Speed Dial numbers. The number
can then be dialed, if appropriate.
379 When the phone user enters this feature code, while
connected to a CO call that has outside party name
information, the display will toggle between the caller's
name and number. If there is no outside party name of
the Expanded CO Call Information ON Displays flag is
disabled, the user will hear a burst of reorder tone and
see the CANNOT ACCESS FEATURE display. If the
Display Outside Party Name On/Off feature code is
programmed in a user programmable button with a lamp,
the lamp will be lit when the outside party name is enable
and off when the outside party name is enabled.
300 Temporarily displays the system date and time, user
name, and extension number during a call or when other
displays are shown.
Feature code 300 displays the IP Address of a phone if it
is in SIP mode.
370 The Do-Not-Disturb feature code halts all intercom calls,
transferred calls, and pages to the phone.
372 The on/off code can be used to turn Do-Not-Disturb on or
off.
Disables/enables the phone's handsfree intercom
319
answering. Incoming intercom calls ring as private calls if
handsfree answering is disabled. (Not used on single line
phones)
365 This feature code is used for leaving and retrieving a
message waiting indication at a called phone or the called
phone's message center. Depending on how the
message was left, the called phone user either retrieves
the message from their message center or from the
phone that left the message.
366 Allows the phone user to cancel a message waiting
indication that they left at another phone.
368 Cancels a message waiting indication that is waiting at
the phone without requiring the user to respond to it. (Or,
press the asterisk [*] button while viewing the message).
367 Leaves a message waiting indication at a phone without
first placing an intercom call.
314 Turns the microphone on or off during a call. If muted, the
phone user can hear the other party, but the party cannot
hear the phone user. (Not used on single line phones)
7 When followed by a paging zone code (0-9 or 0-49), it
allows announcements to be made through phone
speakers and any external paging speakers in the page
zone.
325 Halts pages through the phone speaker or allows them to
be received again. (Not used on single line phones)
397 User-programmable feature buttons and Stations Speed
Dial buttons can be programmed using this feature code.
(Not used on single line phones)
331 Allows the phone user to route ringing outside, intercom,
and camped on calls to another phone, hunt group, or
outside number. Routing of the redirect call is still subject
10