The Solo Gimbal; In The Box; Gimbal Installation - 3DR Solo User Manual

3

The Solo Gimbal

The optional Solo Gimbal holds your GoPro® camera and lets you control it remotely. It taps Solo's intelligence to
get perfectly automated shots, plus rock-solid footage, GoPro® control and charging, and long-range HD video
feed. With the 3-Axis Solo Gimbal, you get:
• Smooth and fluid HD footage every flight.
• Start and stop recording (HERO4 models) while you fly so you can pick and choose the shots you want.
• Footage stabilized to within 0.1 degree of pointing accuracy for enhanced Smart Shots.
• Fine-grain camera tilt control, including angle presets and instant speed adjustment.
Note: If you purchased the Solo with 3-Axis Gimbal package, skip to section "Camera Installation" on page 19.
3.1

In the Box

The Solo 3-Axis Gimbal package includes the Solo Gimbal, the sunshade, four balance weights for the GoPro®
camera, and a screwdriver for installing the Gimbal.
Solo Gimbal
To install the Solo Gimbal and start utilizing its features, follow these Solo Gimbal installation instructions:
3.2

Gimbal Installation

Before installing the Solo Gimbal, make sure the firmware on Solo and your GoPro as well as the Solo App on your
mobile device are up to date for the best performance.
Recommended versions:
• Solo: 1.2.0 or higher
• Solo App: 1.2.0 or higher
• GoPro: 3.00.00 or higher
3.2.1 Remove The Frame
1. Flip Solo over to access the bottom of the vehicle.
2. The Frame is secured to Solo by three captive screws (permanently attached to the mount to prevent losing
them). Since these screws don't come out all the way, loosen each screw until they can't be backed out any
further.
3. Detach the mount from Solo by gently lifting up on it.
4. Route the HDMI cable out through the mount to complete the separation.
Sunshade Balance weights (4)
Figure 3.1.1: Solo Gimbal Parts
Screwdriver
16