Omcan MS-IT-0195 Instruction Manual page 11

the external side of the blade to check for a slight spud.
We advise performing this operation with the utmost care as the blade is extremely sharp.
If some spud is found, restart the blade by maintaining the wheel button (5) pressed for 10 seconds.
SHARPENING VERSIONS WITH BUILT-IN SHARPENER
To sharpen the blade periodically as soon as the cutting capacity decreases. Please proceed as per the
following instructions:
1. After disconnecting form the mains, clean the blade accurately using denaturized alcohol to degrease it.
2. Loosen the knob (1) and turn the sharpener (2) by 180° and insert the wheels on the slicer blade. Re lock
the knob (1).
3. Operate the switch (3) and press the button (4).
4. Allow the blade to rotate for about 30 to 40 seconds then use the switch (3) to stop it. Brush a pencil lightly
on the external side of the blade to check for a slight spud.
We advise performing this operation with the utmost care as the blade is extremely sharp.
5. If some spud is found, operate the switch (3) again for 3 to 4 seconds by pressing the buttons 4 and 5 at
the same time.
DO NOT PROLONG THIS OPERATION BEYOND THE FEW SECONDS MENTIONED OTHERWISE THE
BLADE EDGE WILL WARP.
6. After completing sharpening, we advise cleaning the wheels using a small brush and alcohol.
7. Now return the sharpener to its original position.
Maintenance
11