Yamaha 2006 FJR1300A Service Manual page 72

Item
Shift arm pinch bolt
Shift rod locknut
Drive shaft dust cover bolt
Final gear oil drain bolt
Final gear oil filler bolt
Final drive assembly nut
Final drive pinion gear bearing
retainer
Coupling gear nut
Ring gear bearing housing bolt
Ring gear bearing housing nut
Final gear case stud bolt
Ring gear bearing housing stop-
per bolt
Battery box bolt
Battery stay bolt
Battery holder bolt
Horn bolt
NOTE:
Lower ring nut
1. First, tighten the lower ring nut to approximately 52 Nm (5.2 m·kg, 37 ft·lb) with a torque wrench, then
loosen the lower ring nut completely.
2. Retighten the lower ring nut to 18 Nm (1.8 m·kg, 13 ft·lb) with a torque wrench.
NOTE:
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the flange bolt from the left side to
91 Nm (9.1 m·kg, 66 ft·lb).
2. In the order pinch bolt "2" → pinch bolt "1" → pinch bolt "2", tighten each bolt to 21 Nm (2.1 m·kg, 15
ft·lb) without performing temporary tightening.
3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push the
front axle or lightly tap it with a soft hammer until its end is flush with the front fork. However, if the
surface of the front axle end is not parallel to the surface of the front fork, align a point on the outer
edge of the axle with the fork, making sure that the axle does not protrude past the fork.
4. In the order pinch bolt "4" → pinch bolt "3" → pinch bolt "4", tighten each bolt to 21 Nm (2.1 m·kg, 15
ft·lb) without performing temporary tightening.
Thread
Q'ty
size
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 2
M5 2
M14 1
M14 1
M10 4
M65 1 110 Nm (11.0 m·kg, 80 ft·lb)
M16 1 110 Nm (11.0 m·kg, 80 ft·lb)
M10 2
M8 6
M8 6
M10 1
M6 2
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 2
2-23
TIGHTENING TORQUES
Tightening torque
7 Nm (0.7 m·kg, 5.1 ft·lb)
4 Nm (0.4 m·kg, 2.9 ft·lb)
23 Nm (2.3 m·kg, 17 ft·lb)
23 Nm (2.3 m·kg, 17 ft·lb)
42 Nm (4.0 m·kg, 29 ft·lb)
40 Nm (4.0 m·kg, 29 ft·lb)
23 Nm (2.3 m·kg, 17 ft·lb)
9 Nm (0.9 m·kg, 6.5 ft·lb)
9 Nm (0.9 m·kg, 6.5 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
Remarks
LT
Left-hand
thread
Stake
LT
Left-hand
thread