Maintenance - Gardena TCS 720/20 Operation Instructions Manual

To tilt the motor unit:
-60°
-45°
-30°
-15°
0°
15°
30°
45°
60°
To extend the telescopic
pipe:
4

5. MAINTENANCE

2 3 1
To clean the pruner:
To replace the chain:
For cutting at high and low level, the motor unit
an angle of 60° to – 60° in 15° increments.
1. Keep the orange button
2. Tilt the motor unit
3. Release the orange button
to engage.
5
u
For cutting at high and low heights, the telescopic pipe
continuously extended by up to 45 cm.
1. Loosen the orange nut
2. Extend the telescopic pipe
e
3. Tighten the orange nut
DANGER! Risk of physical injury!
Cut injury when the unit starts accidentally.
v Before you maintain the unit, make sure that the mains
cable is disconnected and the protective cover
over the bar
DANGER! Electric shock!
Risk of injury and risk of damage to property.
v Do not clean the unit with water or with a water jet
(in particular high-pressure water jet).
1. Clean the unit with a damp cloth.
2. Clean the airflow slots with a soft brush (do not use a screwdriver).
3. Clean the bar
DANGER! Risk of physical injury!
Cut injury due to the chain.
v Wear safety gloves when replacing the chain.
When the cutting performance reduces significantly (dull chain), the
chain must be replaced. The Allen key for the screws
a
inside the protective cover
Chain and Bar Art. 4048 or Spare Chain Art. 4049 can be used.
pressed.
u
in the required direction.
5
and allow the motor unit
u
.
e
to the required length.
4
again.
e
and the snap fit
2 3
with a brush, if necessary.
2
. Only the original GARDENA Spare
1
can be tilted at
5
5
can be
4
is slid
1
is closed.
is situated
a
9