Cleaning; If Something Doesn't Work - AVM EVOLUTION MP 3.2 Operating Instructions Manual

9. Select "Restart" in the upper-right corner of the RC S App to restart the internal streaming module of
your AVM device. Then, click on "Back" in the upper-left corner of the RC S App and wait for the pop-
up message "Please wait. Reconnecting" to disappear.
10. Switch your AVM device into stand-by mode by pressing the power-button on the front panel of
the unit.
11. Disconnect the LAN cable from your AVM device.
12. After switiching on your AVM device again by pressing the power-button on the front panel of the
unit, everything is set to use your AVM device in your local WiFi network by using the RC S App.

6 Cleaning

Use a soft cloth and normal glass cleansing fluid.
CAUTION: Make sure that no fluid comes into the unit. Do not use scouring cleaners. They may
damage the surface.

7 If something doesn't work...

Some putative defects are often caused by mistakes in operation. Sometimes other units connected to
the amplifier can cause problems. Therefore please read the following tips before you consult your
dealer.
1. No music playback
a) Inadvertent switching to standby by remote control. Press power button (1). If the LED indicator
and display do not light up a fuse can be blown due to overvoltage (thunderstorm). Please contact
your dealer.
2. Unit switches off during normal operation
This can happen if the temperature inside the unit becomes too high. In this case the Media Player
switches off and the display shows 'overheat'. Switch the unit off and let it cool down for five minutes.
3. RC 9 remote control doesn't work
a) Charge the included lithium-ion battery of your RC 9 remote control (see 1.8.1).
21