Table of Contents
Advertisement
3.7 Programming an individual playlist
If a disc is inside the player You can program Your individual playing sequence as follows: Tip on the button
program (5) for less than 1 second to enter the playlist-menu.
Pressing the < / > buttons (3, 4) allows You to select a title. Pressing the program button (5) stores the
selected title in the playlist. If the playlist is completed you can start playing by pressing the play button (12).
Pressing stop (11) once stops the CD3NG but doesn't erase the playlist. Pressing stop (11) twice or opening
the loader makes the CD3NG returning to the normal mode.
3.8 Select filter
Press the button filter (6) to select the filter characteristic You like most out of seven different settings. Chose
the filter using the < / > buttons (3, 4). This function works as well in STOP and PLAY mode.
The different filters are:
192 kHz / 24 Bit / smooth, 96 kHz / 24 Bit / sharp, 96 kHz / 24 Bit / smooth, 48 kHz / 24 Bit / sharp, 48 kHz /
24 Bit / smooth, 44,1 kHz / 24 Bit / sharp, 44,1 kHz / 24 Bit / smooth.
The filter setting is according to your personal taste. The tonal results can vary depending on the recording
mode of the CD.
3.9 Display off
Press the dis off button (15) to switch the display off while the CD3NG is playing. (Display will automatically
light up in PAUSE and STOP mode). Press the button again to switch the display permanently on.
4. Remote control (option)
As accessories we offer different infrared remote control transmitters. Ask Your dealer.
5. Cleaning
Use a soft cloth and normal glass cleansing fluid.
CAUTION: Make sure that no fluid comes into the unit. Do not use scouring cleaners. They may
damage the surface.
6. If something doesn't work.......
Some putative defects are often caused by mistakes in operation. Sometimes other units connected to the
unit can cause problems. Therefore please read the following tips before You consult Your dealer or us.
Loader closes, but the CD is not recognized
The CD may be inserted upside down or the surface has to be cleaned.
No music although the display shows "play"
Check the cables to the amplifier.
Infrared remote control doesn't work
Check the batteries of Your remote control transmitter
Point with the remote control transmitter directly to the player.
9
Advertisement
Table of Contents
