Table of Contents
Advertisement
3.2 Reset menu (Factory Settings)
This function cancels certain or all settings and makes the unit return to default settings.
To enter the reset menu, please switch off your device on the rear of the unit at the mains switch (29).
Keep both the REPEAT button (6) and the STOP button (10) pressed while you switch on the unit again
(29). As soon as the display shows the reset menu you can release both buttons (6, 10).
Select if you just want to clear the input names (NAMES) with the PAUSE button (10) or reset the unit
completely (ALL) by pressing the PLAY button (12).
Pressing the STOP button (10) will bring the unit back to normal operating mode without resetting any
item (CANCEL).
4 Cleaning
Use a soft cloth and normal glass cleansing fluid.
CAUTION: Make sure that no fluid comes into the unit. Do not use scouring cleaners. They may
damage the surface.
5 If something doesn't work...
Some putative defects are often caused by mistakes in operation. Sometimes other units connected to
the amplifier can cause problems. Therefore please read the following tips before you consult your
dealer.
1. No music playback
a) Inadvertent switching to standby by remote control. Press power button (1). If the LED indicator
and display do not light up a fuse can be blown due to overvoltage (thunderstorm). Please contact
your dealer.
2. Unit switches off during normal operation
This can happen if the temperature inside the unit becomes too high. In this case the CD player
switches off and the display shows 'overheat'. Switch the unit off and let it cool down for five minutes.
3. Remote control doesn't work
a) Change the battery of your RC 3 remote control (see 1.7.1).
b) Point with the remote control transmitter directly to the unit.
5. The display shows „now disc" although a CD is inserted
a)
Please make sure the CD has not been damaged and is inserted with the correct side facing up
b)
Please clean your CD with a soft cleaning cloth
12
Advertisement
Table of Contents
