Calibrating The Compass; Compass Sensor - Toyota sienna 2004 Service Manual

If the direction is not indicated or the
system does not operate properly, contact
your Toyota dealer.
324
04 SIENNA_U (L/O 0408)

Compass sensor

The compass sensor is on the roof of
the vehicle.
NOTICE
Do not put magnets or a metal object
on or near the roof of the vehicle.
Doing this may cause malfunction of
the compass sensor.
I n f o r ma t i o n P r o v i d e d b y :
CALIBRATING THE COMPASS (deviation
calibration)
The direction display on the compass
deviates from the true direction deter-
mined by the earth's magnetic field. The
angle of deviation varies according to the
geographic position of the vehicle.
To adjust for this deviation;
1. Stop the vehicle in a level place and
switch the display to the outside tem-
perature. (To switch to this mode, see
"—Outside temperature and cruise in-
formation display" on page 321.)
2. Push and hold both the "MODE" and
"E/M" buttons simultaneously for 5 sec-
onds until the "VAR" indication appears
on the compass display.
3. Push the "E/M" button several times
until the desired zone number appears
on the compass display.
If the button is not pushed for 10 sec-
onds, the display returns to the compass/
outside temperature mode and the number
that is last set is memorized.
To select the zone where the vehicle is
currently located, refer to the following
map.
2004 SIENNA from Aug. '04 Prod. (OM45422U)