Ignition Switch With Steering Lock - Toyota sienna 2004 Service Manual

Ignition switch with steering
lock
"START"—Starter motor on. The key
will return to the "ON" position when
released.
For starting tips, see page 393 in Section
3.
It is not a malfunction even if the needle
of the tachometer, fuel gauge or engine
coolant temperature gauge returns to the
bottom position when the ignition switch is
turned to the "START" position.
178
04 SIENNA_U (L/O 0408)
"ON"—Engine on and all accessories
on.
This is the normal driving position.
It is not a malfunction even if the needle
on the instrument panel may move when
the ignition switch is turned to the "ON"
position.
"ACC"—Accessories such as the radio
operate, but the engine is off.
If you leave the key in the "ACC" or
"LOCK" position and open the driver's
door, a buzzer will remind you to remove
the key.
"LOCK"—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
You must push in the key to turn the key
from "ACC" to the "LOCK" position. The
selector lever must be put in the "P" posi-
tion before pushing the key.
Vehicles with engine immobilizer system—
Once you remove the key, the engine im-
mobilizer system is automatically set. (See
"Engine immobilizer system" on page 13
in Section 1−2.)
I n f o r ma t i o n P r o v i d e d b y :
When starting the engine, the key may
seem stuck at the "LOCK" position. To
free it, first be sure the key is pushed all
the way in, and then rock the steering
wheel slightly while turning the key gently.
NOTICE
Do not leave the key in the "ON"
position if the engine is not running.
The battery will discharge and the
ignition could be damaged.
2004 SIENNA from Aug. '04 Prod. (OM45422U)