Toyota sienna 2004 Service Manual page 319

R
1. Decide which of 3 HomeLink buttons
you want to program. Push and hold
down one of the buttons until the indi-
cator corresponding to the selected
channel begins to flash.
2. Place your hand−held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
R
the surface of the HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
3. Simultaneously press and hold
hand−held garage transmitter button
R
along with the selected HomeLink
ton.
4. When the indicator light on
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
04 SIENNA_U (L/O 0408)
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
R
programmed HomeLink button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
R
heading "Programming a rolling code sys-
tem".
the
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink button to program
but-
another device.
Programming a rolling code system
the
If your device is "Rolling
equipped, it is necessary
steps 1 through 4 under the heading
"Programming the HomeLink
R
by
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer to
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
I n f o r ma t i o n P r o v i d e d b y :
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle's pro-
R
)
grammed HomeLink
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
motor should now
R
Code" HomeLink unit and be able activate the
to follow
garage door up/down.
4. Repeat steps 1 through 3 for each re-
R
" before
maining HomeLink
another rolling code system.
the owner's
2004 SIENNA from Aug. '04 Prod. (OM45422U)
R
button twice. The
recognize the
R
button to program
319