Toyota sienna 2004 Service Manual page 200

Dynamic laser cruise control should not
be used in circumstances which are inap-
propriate for any cruise control, such as
entering free way on−ramps or off−ramps.
CAUTION
D
Do not use dynamic laser cruise
control when exiting from or when
entering or merging onto a freeway.
When you are following a slower
moving vehicle and exiting, the sen-
sor does not detect the vehicle and
will accelerate to the preset speed.
200
04 SIENNA_U (L/O 0408)
D
If other vehicles are driving outside
of the laser radar detection range,
a delay in the detection of the ve-
hicle cutting in at short range or
failure to detect a motorcycle run-
ning on the side of the same lane
will occur. In this case, the dynamic
laser cruise control system will not
function properly.
D
When a slower vehicle in front of
you leaves the lane, the dynamic
laser cruise control will no longer
detect a vehicle ahead and will at-
tempt to accelerate the vehicle to
the faster preset speed.
I n f o r ma t i o n P r o v i d e d b y :
TURNING THE SYSTEM ON
To operate dynamic laser cruise control,
press the "ON−OFF" button. This turns the
system on. When the "CRUISE"
"READY" indicator lights in the instrument
cluster come on, you can now set your
desired cruising speed and vehicle−to−ve-
hicle distance. Pressing the "ON−OFF"
button again will turn the system com-
pletely off.
When the ignition is turned off, the system
is also automatically turned off. To use
dynamic laser cruise control again, press
the "ON−OFF" button again to turn it on.
2004 SIENNA from Aug. '04 Prod. (OM45422U)
and