Rs 485 Interface; Interface For Display Board; Usb-Interface - ALGE-Timing Timy Manual

5.2.2.

RS 485 Interface:

This function is not available yet!
5.2.3.

Interface for Display Board:

Transfer Format:
Transfer Speed:
Transfer Protocol:
NNN.xxxxxxxxM:SSxxxx(CR)
NNN.xxxxHH:MM:SSxxxx(CR)
NNN.xxxxHH:MM:SS.zxx(CR)
NNNCxxxxHH:MM:SS.zhtRR(CR)
NNNCxxxxHH:MM:SS.zhtxx(CR)
NNNDxxxxHH:MM:SS.zhtRR(CR)
NNNDxxxxHH:MM:SS.zhtxx(CR)
NNNAxxxxHH:MM:SS.zhtRR(CR)
NNNBxxxxHH:MM:SS.zhtRR(CR)
NNNExxxxHH:MM:SS.zhtRR(CR)
NNNFxxxxHH:MM:SS.zhtRR(CR)
NNNGxxxxHH:MM:SS.zhtRR(CR)
NNNHxxxxHH:MM:SS.zhtRR(CR)
NNNIxxxxHH:MM:SS.zhtRR(CR)
NNNSxxx©xxxxsxss.ssxRR(CR)
NNN .....................ID-number (hunderts-, tenths- and single, digit 1 to 3)
. ............................ a point on the fourth sign is a identification for a running time
HH:MM:SS.zht .....time in hours, minutes, seconds, and 1/1000 seconds
© speed measurement: the following ASCII character output::
01 Hex. for km/h, 02 Hex for m/s, 03 Hex. for mph
RR ........................rank
x ...........................blank
(CR) ...................... carriage return
5.2.4.

USB-Interface:

This function is not available yet!
Version: E-2001-12-20
Timy Timy
Timy Timy Timy
1 start bit, 8 data bit, no parity bit, 1 stop bit
2,400 Baud factory adjustment (standard baud rate for ALGE-GAZ4)
adjustable: 2400, 4800, 19200, 28800, 38400
ASCII
running time (without 1/10 sec.)
running time (without 1/10 sec.)
running time (without 1/10 sec.)
channel c1
channel c1
channel c1
channel c1
channel c2
channel c3
channel c4
channel c5
channel c6
channel c7
channel c8
speed
finish time with rank
finish time without rank
total time with rank
total time without rank
1st intermediate time
2nd intermediate time
3rd intermediate time
4th intermediate time
5th intermediate time
6th intermediate time
7tj intermediate time
Page 24