Software Registration; Select Language; Memory; Info-Mode - ALGE-Timing Timy Manual

2.6.

Software registration:

This function is not available yet!
2.7.

Select Language:

This function is not available yet!
2.8.

Memory:

The memory of the Timy can hold about 12.000 times. When
switching the Timy on it is possible to clear the memory. The
display will always inform you about the amount of used and
empty memory space.
2.9.

Info-Mode:

If you press at the same time <2nd> and
Info-Mode. In the Info-Mode you can get important system data
about the Timy.
External Power Supply – Yes or No
Timy program version
Timy boot version
Internal battery voltage
Timy voltage for power out
Integrated printer or no integrated printer
Impulse channel condition ( co, c1, c2 und c3 )

2.10. Synchronisation:

To synchronize the Timy you have to do the following:
connect Timy with cable 000-xx or 004-xx with the other
timing device(s)
switch Timy on
decide if you want to clear or keep the data in the memory
If the Timy display shows „SYNC-TIME" you have the option:
• shown time and date is correct:
• press key <OK> (green or red) or <F0>. The sync-
impulse is given automatically at the next full minute
• shown time and/or date must be corrected:
• press key <F3> and input the correct time and date
(confirm always with <OK>)
• synchron start with key <START> or through external
impulse from channel 0
Version: E-2001-12-20
Timy Timy
Timy Timy Timy
, than you reach the
Cable 004-xx
Page 16