Vibration Damper; Disassembly / Assembly - Dolmar PS-6100 Repair Manual

09 VIBRATION DAMPER

D
2
Repair Manual PS-6100 / PS-6100 H
Disassembly
CAUTION: To prevent cuts, wear protective
gloves and disassembly the spike bar (2
screws)!
Note: For removal and installation, guide the
Torx screwdriver through damper springs.
A
1
B
C
Damper spring A
Remove the cover for easier disassembly.
Unscrew bolt 1 from damper spring A.
Damper spring B and C
Remove the sprocket guard, bar, and chain.
Remove starter housing (see chap. 06).
Unscrew bolts 2 from damper springs A, B
and C.
NOTE: The engine unit is connected to
the tank unit by fuel lines and the throttle
cable. The two units cannot be separated!
Carefully lift the engine unit on the clutch side
over damper springs B and C (spread the
engine unit slightly apart from the tank).
Unscrew the damper springs.
Damper spring D
Note: Damper spring D cannot be removed
until damper springs A, B and C have been
removed.
Carefully lift the engine unit on the fan side
over damper spring D and spread the engine
unit slightly apart from the tank. Unscrew the
damper springs.
Assemble in reverse order.
Make sure the fuel lines remain connected
to the tank.
2
22