05 OIL PUMP
1
A
4
3
General
The oil pump is driven by the clutch drum.
Lugs on the clutch drum transfer the power to
the drive arms of the oil pump drive 1.
The drive worm of the oil pump drive engages
in the teeth of the oil pump 3.
This means that oil is pumped only when the
chain is running.
The oil ow rate can be adjusted with
adjusting screw A:
• Turn right for more oil
• Turn left for less oil
Disassembly
Remove the clutch drum and clutch, see
chapter 04. Remove brake band, see chapter
03.
Turn the oil pump drive 1 counter-clockwise
and pull it off the shaft.
Repair Manual PS-6100 / PS-6100 H
6
A
3
5
2
8
A
Pull the oil pressure line 2 from the oil pump.
Unsrew screw 4 and remove the oil pump.
Remove spacer ring 5 from the crankshaft.
Note: Make sure to install in the right position.
See illustration.
2
1
The suction line 6 remains in the crankcase.
It extends into the oil tank. To remove it,
carefully pull on the connection to the oil
pump.
Removing the oil pump
Push the adjusting screw A up against the
spring pressure and turn it until the pin 7 goes
into the assembly slit 7. If necessary press the
supply piston 8 in somewhat.
Note: When assembling put the adjusting
screw A counterclockwise to stop.
7
Removing the oil tank vent
Note: The ventilation valve 9 must be
punched into the tank.
Press in a new valve about 2 mm deep under
the housing surface.
Make sure that the ventilation channel 10 is
free of deposits. Clean if necessary.
9
10
12