Vibration Dampers, Handle - Dolmar 109 Service Manual

DOLMAR GmbH
08 Vibration damping system, handle
1
08-01 Removing and fitting the handle
For the removal of the handle unscrew
(1) 2 x tank screws (lateral)
(2) 2 x tank screws (bottom)
(3) 1 x vibration damper
(4) catching band.
7
08-02 Replacing the vibration damper (MS)
Remove screws (7) + (8), and using a Torx
spanner unscrew the screws located under-
neath.
Note: screw(8) is located under the auxiliary
filter.
10
08-03 Damper system design
The fourth vibration damper (6) with pot (10)
and catching band (4) is located between the
supporting web (11) and the crankcase.
14
4
3
2
8
11
6
5
08-02 Replacing the vibration damper (KS)
Unscrew screws (5), (3) + (4). Always use
special tool, no. 944 500 621 when removing
or fitting vibration dampers (6).
9
08-02 Damping system design
Three identical vibration dampers (9) are
provided on the tank housing.
6
9
9