Cleaning The Glass - Heatilator GCBC36LE Installation Instructions Manual

Venting system inspection
The appliance and venting system should be inspect-
ed before use, and at least annually, by a qualified
field service person, to ensure that the flow of com-
bustion and ventilation air is not obstructed.

Cleaning the glass

See Figure 7.
Never operate this appliance without the glass prop-
erly secured in place or if the glass is broken.
Log Removal/Replacement
If removal of the logs becomes necessary,
remove the two screws at each end of the
grate. Grasp the grate as shown. Pull the log
up and off the burner. See Figure 8.
To replace the logs, grasp the grate as shown.
Lower the log set onto the burner pan. Attach
the two screws at the ends of the grate.
12-97
F. CLEANING THE GLASS
7
In the event of glass breakage, carefully remove the
glass frame. This will allow the removal of all glass
fragments and sheet metal edge protection strips.
Vacuum all remaining glass pieces with a shop vac.
(DO NOT VACUUM IF PIECES ARE HOT.)
Replace glass with only a Heatilator glass panel
assembly ordered direct or through your local dis-
tributor. Never use substitute material. Only fully
tempered soda lime safety glass or ceramic glass
may be used on this appliance.
Figure 7
Glass Cleaning
Safety Note
Handle glass with care to
avoid striking, scratching or
slamming shut. NEVER
clean glass when hot.
Keep children and pets a
safe distance away.
Figure 8
Log Removal
28887A