Cleaning The Glass - Heatilator CALIBER DESIGNER DIRECT VENT Installation And Operating Instructions Manual

4. Cleaning the Glass

Note:
32
9
Place screen into top screen retainers,
lift and rotate towards the appliance.
Place on bottom retainers.
8
Reattach the five
Quick Access
Latches™
7
To replace, place glass
on
bottom retainers.
6 Set glass on non-
abrasive surface.
Clean using a non-
abrasive, mild
cleaning solution
(i.e. Brasso).
5
Pull top of glass
away from
appliance.
35593 Rev G
CALIBER DESIGNER DIRECT VENT
WARNING!
4
Pull and release the five
Quick Access Latches.
WARNING!
10 Close control access
panel.
11
Replace hood.
1
Pull out to remove hood and
expose three Quick Access
Latches.
2
Open control access
panel, locate handle and
two Quick Access
Latches.
3
Rotate bottom of screen away
from appliance and lower out
of top retainers. Set screen
aside.
01/04