Lighting Instructions; To Turn Off Gas To Appliance - Heatilator GCBC36LE Installation Instructions Manual

A. LIGHTING INSTRUCTIONS FOR ELECTRONIC
Determine the Ignition
To determine whether your appliance is an electronic
ignition or a standing pilot ignition, remove the lower
panel to examine the wiring system. If your system has a
red ignitor button (as shown in Figure 1), you own a
standing pilot ignition fireplace. If no red ignitor button is
present, you own an electronic ignition appliance.
You may also check the rating label located on the inside
of the lower panel to determine ignition type.
ELECTRONIC UNITS
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
o Do not try to light any appliance.
o Do not touch any electric switch; do not use any phone in your building.
o Immediately call your gas supplier from a neighbor's phone. Follow the supplier's instructions.
o If you can not reach your gas supplier, call the fire department.
C. Use only your hand to push in and move the gas control lever or turn the gas control knob.
Never use tools. If the lever or knob will not move by hand, don't try to repair it - call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
1. STOP! Read the safety information above on this label.
2. Turn wall switch to the "OFF" position.
3. This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light burner by hand.
4. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above on this label.
If you don't smell gas, go on to the next step.
5. To turn on burner, turn on all electric power to this appliance.
6. If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your service technician
or gas supplier.
1. Turn off the wall switch.
2. Push gas control lever in and move to the "OFF" position or
push gas control lever to the "OFF" position. Do not force.
12-97
FOR YOUR SAFETY
READ BEFORE OPERATING

LIGHTING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

Standing Pilot Ignition
3. Replace control access panel.
2
Figure 1
28887A