Standing Pilot; For Your Safety Read Before Lighting - Heatilator GCBC36LE Installation Instructions Manual

B. LIGHTING INSTRUCTIONS FOR STANDING PILOT
WARNING: If you do not follow these instructions exactly, a fire or exposion may result causing
property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor's
1. Turn off all wall switches to the appliance.
2
2. Lower control access panel. Turn wall switch to
the "OFF" position or set thermostat to lowest
setting.
3
3. Turn gas line to CLOSED. Wait 5 minutes to
clear out any gas. Then smell for gas, includ-
ing near the floor. If you smell gas, STOP!
Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next
step.
4
4. Turn gas line to OPEN.
5
5. Turn pilot knob clockwise to "OFF". (Knob may
have to be depressed to pass "PILOT" posi-
tion.)
6
6. Locate pilot assembly inside unit.
7
7. Locate red ignitor button.
8
8. Turn pilot knob to "PILOT" and push in.
9. Continue to hold in pilot knob and push the red
ignitor button 12-15 times until small blue pilot
flame appears.
10. Continue to hold in pilot knob for approximately
one minute. Pilot should remain lit. If pilot
goes out, wait 5 minutes and repeat Steps 4-9.
11
11. Release and turn knob counterclockwise to
"ON".
12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance"
and call your service technician or gas supplier.
NOTE: To light main burner, turn wall switch to
"ON". Do not light by hand.
1. Turn off the wall switch or set thermostat
to the lowest setting.
2. Lower control access panel.
12-97

STANDING PILOT

FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label!
3
4
TO TURN OFF GAS TO APPLIANCE
phone. Follow the supplier's instructions.
• If you cannot reach your gas supplier, call the fire depart-
ment.
C. Use only your hand to push in or turn knob. Never use tools. If
the knob will not push in or turn by hand, don't try to repair it;
call a qualified service technician. Forced or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
2
3. Turn gas line to CLOSED position. Do not force.
4. Close control access panel.
3
6
7
8
5 11
28887A