Contec BX-100n-DC5000-C01 User Manual page 114

Offending address not found
This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY ERROR
messages when the segment that has caused the problem cannot be isolated.
Offending segment
This message is used in conjunction with the I/O CHANNEL CHECK and RAM PARITY ERROR
messages when the segment that has caused the problem has been isolated.
Press a key to REBOOT
This will be displayed at the bottom screen when an error occurs that requires you to reboot. Press any
key and the system will reboot.
Press F1 to disable NMI, F1 to REBOOT
When BIOS detects a Non-maskable Interrupt condition during boot, this will allow you to disable the
NMI and continue to boot, or you can reboot the system with the NMI enabled.
RAM parity error
[CHECKING FOR SEGMENT...]
Indicates a parity error in Random Access Memory.
Detected unexpected EISA board
[PLEASE RUN EISA CONFIGURATION UTILITY]
A valid board ID was found in a slot that was configured as having no board ID.
CAUTION
When this error appears, the system will boot in ISA mode, which allows you to run the EISA
Configuration Utility.
Detected unexpected EISA board
[PLEASE RUN EISA CONFIGURATION UTILITY]
The board installed is not responding to the ID request, or no board ID has been found in the indicated
slot.
CAUTION
When this error appears, the system will boot in ISA mode, which allows you to run the EISA
Configuration Utility.
Slot not empty
Indicates that a slot designated as empty by the EISA Configuration Utility actually con-tains a board.
CAUTION
When this error appears, the system will boot in ISA mode, which allows you to run the EISA
Configuration Utility.
BX-100n User's manual
5. BIOS Setup
107