Stop Tether; Control Panel Button Descriptions - Trackmaster TMX58 Owner's Manual

Operating Instructions

Control Panel Button Descriptions:

NOTE: You must attach the Stop Tether lanyard strap to your wrist before pressing any other
buttons on the TRACKMASTER
should you fall.
Stop Tether: This switch is located on the console in the lower right hand portion, just right of
center. It is used in combination with a lanyard and wrist cuff which is to be worn by the user at all
times during the operation of the TRACKMASTER
"C" shaped piece that engages the Stop Tether which must be in place for the machine to run. Simply
insert the clip on the shaft directly behind the red cap on the switch. The TRACKMASTER
designed to stop all functions upon activation of the Stop Tether. Operation cannot resume until the
"C" shaped clip is returned to its operational position.
Start button: The green start button is used to begin a workout session. When a new user steps onto
the machine and the start up information is displayed on the screen, pressing the start button will
immediately begin a 3 second countdown of the belt start at minimum belt speed. When a user has
previously selected a pre-programmed workout, pressing the start button will start the first phase of
the program.
Stop buttons: The red hexagon shaped stop buttons are used to end an exercise session. Anytime that
it is pressed during a workout session, the running belt will gently come to a stop and be locked into
place for 2 minutes or until a new workout session is started. Upon pressing the stop button, the
incline of the running deck will decrease to 0 percent and the cumulative user data information will
displayed for 60 seconds. To start a new workout session, press the Start button or Program button.
Enter button: The yellow enter button is used to enter the user's weight, age, and gender when
prompted by the display screen at the beginning of a workout session as well as entering data when
creating or modifying workout programs.
Cool Down button: The blue cool down button will incrementally slow the running belt speed down
by .1 mph or kph and decrease elevation by .5% elevation incrementally over 90 seconds every until
the running belt stops and elevation returns to 0% elevation.
Program / Select button: The black program button calls up a list of pre-programmed workouts and
is used to select segments of a workout when creating or modifying a workout routine.
Speed Minus "Slower": The triangular speed minus button decreases the speed of the running belt
by .1 mph or kph each time it is pressed while the belt is moving. Pressing and holding the speed
minus "slower" button while the belt is moving will decrease the speed of the running belt at an
accelerated rate until it is released.
Speed Plus "Faster": The triangular speed faster button increases the speed of the running belt by .1
mph or kph each time it is pressed while the belt is moving. Pressing and holding the speed plus
"faster" button while the belt is moving will increase the speed of the running belt at an accelerated
rate until it is released.
6-2
®
control. The lanyard will stop the moving running belt
®
. The opposite end of the lanyard has a plastic
TMX428 Owner's Manual
TRACKMASTER
®
is
August 2013